XJTAG Hardware
XJTAG produces JTAG controller hardware for use with its software. This hardware connects the PC to the hardware under test, and has a flexible pin-out to allow easy connection and test setup.
XJTAG also produces a range of other hardware - for example the XJIO board which enhances the testing that XJTAG can perform. XJTAG also produces XJDemo boards, which are used to complete the XJTAG Tutorial training exercises.
JTAG Controllers
JTAG Controllers that are no longer supported
The original XJLink JTAG controller is no longer supported in this version of XJTAG software.
Although it cannot be used as a JTAG controller in XJTAG 4.0 or later, you can still use it with earlier software versions. You can also use whatever licence you have for an original XJLink to enable other supported JTAG controllers.
Other XJTAG Hardware
Safety Notice
The XJTAG hardware is directly connected to the ground of the computer via the cable. It is important to ensure that no current flows in the ground. The ground should not be used as a protective safety earth. XJTAG hardware should not be connected to boards unless the board is also referenced to ground. If it is required that the XJTAG hardware is connected to a non-ground reference board then some form of isolation of the JTAG interface is required.
XJTAG v4.1.100