Run Tests Screen

The Run Tests screen allows tests to be performed on your circuit. This means that your tests (and development hardware) can be verified without leaving XJInvestigator.

This screen is very similar in operation to the main screen of XJRunner with certain differences:

• Only a single circuit can be tested at once - i.e. only one XJLink will be active (in XJRunner multiple XJLinks are supported).
• XJLink information and test run status information are shown to the right of the Run and Stop buttons, rather than in a tab at the top.
• XJInvestigator can only be used by users with Enhanced Testing privileges, so basic users will not be allowed to log in.

Setup

The Run Tests screen uses settings from the Project Management dialog. Any changes made on the Run Tests screen will only be remembered whilst the project is open. Changes made using the Project Management dialog will reset any changes made on the Run Tests screen.

Running Tests

Tests can be started and stopped using the Run button and Stop buttons respectively. Test output appears in the large panel on the left.

The Test List on the right shows all tests in the current project, but only tests that are currently enabled will actually be run. The toolbar at the bottom of the Test List contains several additional debugging options.